Aad507e915377369d7f599761e174c44?default=blank&size=170

ampirical2016

  • Joined on Dec 08, 2015
  • Unknown

Activity

Commented on Ducati 1199 Superbike (Complex) over 3 years ago
I have almost got all the parts printed. Do you have an instruction or illustrations as to how these parts connect. Thanks
Commented on Men's Wallets by XYZ Workshop over 3 years ago
I tried to customize your template per the instructions using Tinkercad. All seemed ok until i started to print. After the 1st layer got laid down everything failed. After analyzing the Tinkercad model and the Cura model, Tinkercad created a bunch of voids where it should have been solid, and basically did not read the .stl file at all, totally messed it up. Going to have to try other software.
Commented on Men's Wallets by XYZ Workshop over 3 years ago
Good Point
Commented on Men's Wallets by XYZ Workshop over 3 years ago
Thanks I will try the .8mm nozzle. I have a heated bed that should be good I hope. Can put some glue down as I don't have any tape.
Commented on Men's Wallets by XYZ Workshop over 3 years ago
ok fixed that issue, due you think its safe to print with an .8 nozzle or .6 nozzle to brink the time to print down to less that 7 hours?
Commented on Men's Wallets by XYZ Workshop over 3 years ago
I am having trouble with settings Layer Height: .06mm Shell thickness: 0.4mm Bottom/Top Thickness: 0.6mm Fille Density: 50% Print Speed: 10 mm/s Nozzle: 0.4 I look the layers view mode and there is nothing. What am i missing? Thanks
Favored Filament Clip 3mm or 1.75mm over 3 years ago
Favored Makey Eggmass over 3 years ago