Favored Ultimaker2 Cable Chain over 5 years ago
Commented on Printrbot Metal Plus Alternative Fan Shroud about 6 years ago
<p>What material are you printing this with?</p>
Contributed on Printrbot Metal Plus cable chain about 6 years ago
- Printed on:
- Printrbot Plus Metal
- Printed perfectly at .2mm layer height, with supports. I accidentally used 30% infill so you could probably drive over the motor mount with a car and not break it. Motor mount fit too tightly for me, but that could be due to my printer's/filament's calibration.
- When the printer is moving on the X axis I can see that there is no movement of the cables by the motor anymore. The motor mount fit VERY snug. It became a little stuck near the end and I had to force it with clamps. If I had to print it again I would shrink the mount slightly before printing, but that might be just for my printer. Normally I have copper RAM heatsinks on the top of my motor to help cool it. The only place I could put them with the motor mount installed was on the back of the motor, which meant I could only use 3 instead of 4. Hasn't seemed to make a difference, and the motor/extruder doesn't overheat.
Commented on Printrbot Metal Plus cable chain about 6 years ago
<p>Just had my stepper motor wires break internally, right at the motor. Never had this problem with my other Printrbots, but then again they both had points near the extruder to anchor the cables. Printing this up now.</p>
Favored Printrbot Metal Plus cable chain about 6 years ago
Commented on Printrbot Metal Plus Simplified fan mount over 6 years ago
Do you think this could be used to accommodate a thicker fan? The official Printrbot fan shroud can only take a 10mm fan. I always want more cooling. I'm printing this up next.
Followed printrbot over 6 years ago
Favored Proximity Clip/Standoff almost 7 years ago
Published Printrbot Octoprint Wi-Fi-Pi camera case front for dual extruder almost 7 years ago
Published Printrbot Plus 1404/2.4 Dual Extruder 60mm Extruder Fan Mount almost 7 years ago
Published Printrbot Plus 1404/2.4 Dual Extruder Fan Shroud almost 7 years ago
Favored Printrbot LCD Box almost 7 years ago
Favored Printrbot Power Tower with Spool Rack almost 7 years ago
Favored Printrbot Universal Spool Rack almost 7 years ago
Favored Printrbot Raspberry Pi Camera Case almost 7 years ago