D7bc8628279e0e065775794a44651257?default=blank&size=170

CptanPanic

  • Joined on Jun 03, 2014
  • Unknown
  • 6 times favorited
  • 606 times downloaded

Activity

Commented on Smartcore over 5 years ago
What are you using for non-contact proximity z probe?
Favored Quick-print gear bearing over 5 years ago
Commented on RAMPS case with 80mm fan mount over 5 years ago
With that large of fan on top, it would be good if there were some vent holes on the side to let air in/out.
Favored Spool holder for Prusa i3 over 5 years ago
Commented on feeder for "Ultimaker 2 Rail System" over 5 years ago
Would it be possible for you to document all the bolts, nuts, and bearing needed to build this from scratch?
Favored UM2Feeder V3.1.1 over 5 years ago
Favored UM2 Feeder over 5 years ago
Favored Alternative UM2 Feeder - version two over 5 years ago
Favored feeder for "Ultimaker 2 Rail System" over 5 years ago
Commented on Prusa i3 E3D V6 Bowden and Induction Sensor Mount over 5 years ago
How well does this work? Can you run M48 (Marlin) to see repeat-ability stats?
Followed fixers.gr over 5 years ago
Favored RAMPS case with 80mm fan mount over 5 years ago
Followed Richard Horne over 5 years ago
Favored DC motor closed-loop control software over 5 years ago
Favored T-Lock Bayonet Joint about 6 years ago
Published Twisted organic vase about 6 years ago
Favored Sli3DR - (pronounced Slider) 3D Printer about 6 years ago