Span2 gotabadassoverhere3deditora

czucker

  • Joined on Mar 24, 2014
  • chris.zucker@mac.com
  • 7 times favorited
  • 2,692 times downloaded

Activity

Commented on Modified SP3D Feeder for MK8 Drive Gear almost 3 years ago
Thanks. Depending on your spring, it can be pretty hard to push. I ended up printing a thumb screw nut to make it a little bit easier.
Commented on UM2 Feeder - SP3D Version about 3 years ago
I made some modifications to this design to get it working on my Frankenstein UM Original (https://www.youmagine.com/designs/modified-sp3d-feeder-for-mk8-drive-gear). Those aside, I have to say this is probably the best feeder that I've bolted on, and I've tried many over the years. Thanks!
Updated Modified SP3D Feeder for MK8 Drive Gear about 3 years ago
Updated Modified SP3D Feeder for MK8 Drive Gear about 3 years ago
Updated Modified SP3D Feeder for MK8 Drive Gear about 3 years ago
Updated Modified SP3D Feeder for MK8 Drive Gear about 3 years ago
Updated Modified SP3D Feeder for MK8 Drive Gear about 3 years ago
Published Modified SP3D Feeder for MK8 Drive Gear about 3 years ago
Published 8mm Bearing IGUS Style over 3 years ago
Commented on E3d V6 hot end mount almost 4 years ago
<p>I hate to be a pain, but do you think you can export STEP files? I don't have access to SolidWorks.</p>
Commented on E3d V6 hot end mount almost 4 years ago
<p>To keep the bearing securely in place I heated the inside of the hole slightly with a soldering iron. Just enough to soften the material a bit (ABS in my case). Then I just pressed the bearing in and it fit very well.</p>
Favored Ultimaker 2 Bowden Clip almost 4 years ago
Favored Knobs and Covers almost 4 years ago
Contributed on Alternative UM2 Feeder - version two almost 4 years ago
Carousel thumb img 20150526 230540
Printed on:
ultimaker original
Result:
Good Results
Feedback:
I slapped one on my Frankenstein UM Original with an MK7 gear that I had laying around. I also had to add a 4mm Nema 17 suport under the feeder to clear the lip on the UM Original (https://www.youmagine.com/designs/stepper-motor-nema-17-support). It works pretty good. I've had the motor slip a bit, and am thinking of adding a high torque 60mm stepper.
Contributed on Motor corner alternative about 4 years ago
Carousel thumb img 20141231 172722
Printed on:
ultimaker original
Result:
Excellent fit.
Feedback:
The part is printed in red colorFabb PLA/PHA and the spacers in Taulman Bridge. It works like a charm.
Published Leveling Leg for a Bosch Dishwasher almost 5 years ago