×Read this message from Erik, founder of YouMagine

1/4" pipe none tapered

for structual use only

Other

Creative Commons Attribution Share Alike

Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

Learn more or download attribution tags

Description

NOT FOR FLUIDS OR PRESSURE. This was created for a project in which the pipe was used to support a structure, not transfer fluids or pressure. Please note that I printed one out in PLA at 100% infill and did pressure test it with air up to 100psi, but I fear it would not hold up over time and if nicked or dropped it may rupture. Therefore I cannot recommend using it for fluids or pressure.

Materials and methods

It works both horizontal or vertical to print. Both require a little attention to the threads to make them work. Please be careful not to cross thread and put it in sideways.

Documents

Issues

Issues are used to track todos, bugs or requests. To get started, you could create an issue.

Comments

Mini imag0142Dustin published this design ago