Thanks for downloading!
We'd love to hear from you if the print was successful.
10mm base 5050 RGB LED Cover/Mount
A cover for the cheaper "10mm" (Non-Adafruit) versions of the NeoPixelMaker/DIY
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
A Cover and Mount for a 5050 RGB LED with a 9.8mm base. Cutouts at bottom to enable wires in/out to be attached, and 3mm holes for attaching to a flat surface. Flat surface over the LED to diffuse the LED's output and make the colour uniform.
Obviously it should be printed in a clear filament.
The need for support depends on your printer. If it can bridge well, you probably don't need it.
Created with Onshape.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.