You need 1 bending tool and 3(CL) or 4(SPW) of the solder tools. Print the solder tools upside down. Glue 3 or 4 of the solder tools together to make a pyramid.<br><br>I should probably make a tutorial video, but I'm to lazy. So here is a short description:
<br>Bend a 0,8mm copper or welding wire(steel with copper plating) according to the 1-2-3 steps on the first tool.leave 1-2cm of extra wire on each side. <br>1 is the edge of the tool. <br>2 is the pole which adds the bend to the wing.<br>3 adds the bends to solder the ends to the cable. <br>LH means left hand RH means right hand circulating.
<br>The wire should follow the edge of the slope.<br><br>You should end up with one wing of the antenna.
<br><br>Place all the wings in the second tool according to LH and RH. Cut 1mm of a 1,5mm brass pipe and put it over the middle wires (the ones that get soldered to the signal line. Cut the wires. <br>Add the signal line and solder everything together. <br><br>Cut the outer wires, which will be soldered to the hull, 4mm after the bend. Tack them to the hull with solder. Use a thin copper wire (e.g. strand of a flexible cable) and wrap it around the tacked wires. Add more solder.
<br>Your antenna is ready.
<br><br>Feel free to ask me questions if you didn't understand my description.
Creative Commons Attribution Share Alike
