Thanks for downloading!
We'd love to hear from you if the print was successful.
2x2 50 ml Slant Rack
A slant culture rack for holding 4x 50 ml tubes and smaller in 90, 20, and 5 degreesOther
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
This is a small rack for cooling 4 culture tubes at 20 degree inclination. It supports standing at 90 degrees for filling, and also setting at 5 degrees for very shallow slants. The design is largely based on commercial products for the same purpose.
After printing, I annealed it while stuck to the build plate. This allowed for successful autoclaving at 15 psi for 30 minutes. Your result may vary.
Materials and methods
Layer height: 0.15 mm
Orientation: As provided in the STL
If printed in the provided orientation, it shouldn't need any support.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.