Thanks for downloading!
We'd love to hear from you if the print was successful.
'98-'02 Accord Key Fob Shell
Replacement shell for the 6th gen Honda Accord key fobMaker/DIY
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
This is a replacement shell for the key fob that comes with the 1998-2002 Honda Accord. Basically, if your fob looks like this: (http://imgur.com/7mpPUPW), then this should work fine.
Materials and methods
- No supports, 15% infill.
- Print everything flat side down.
- Stick the rubber membrane into the top plate (Note: You may have to trim the top of the membrane down a bit)
- Place the circuit board into the bottom plate.
- Snap together.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.