Thanks for downloading!
We'd love to hear from you if the print was successful.
Adapters for non-round Electrolux vacuum cleaner
Adapts standard 32mm accessories to the fancy new Electrolux vacuum cleanersFor your home
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Apparently Electrolux wanted to make a bad product out of a very good vacuum cleaner, so they made it with a stupidly short hose so you don't reach anything above your shoulder, and to piss everyone off they don't use the standard 32mm round attachment, so no accessories will fit, (except theirs).
So here I am, needing to design adapters and kludge stuff for my "top of the line" expensive "flagship" vacuum...
- One is to mount a regular 32mm (1"1/4) spiral hose found in hardware stores in the gardening section (water ponds and irrigation I guess)
- The other one is to mount "regular" 32mm accessories at the end of the telescopic tube or the handle.
- As an extra you get a plug so no spiders crawl out after sucking them.
The tube profile is the "oval square" found on the EU096SBM "Ultraone" and similar.
Just print them! No support needed.
You also get my Solidworks source files if you want to change or improve.
Seriously Electrolux, for that price, the length of the hose... come on!
Materials and methods
Just print! PLA is fine so far
Issues are used to track todos, bugs or requests. To get started, you could create an issue.