Thanks for downloading!
We'd love to hear from you if the print was successful.
Adapters for UMO+ for Gudo's Bed stabilizer
Parts to install the Gudo Bed stabilizer
3D printer parts and enhancements
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Attribution
Gudo
Description
Print two parts, mirroed.
AFAIK on UMO it might hit the motors, but I'm 100% not sure. because the umo frame is slightly smaller on width. For the umo frame I have I had to file a bit some parts and change the x/y motor plastic holders. SO, MIND THE GAP ;)
For umo+ it works quite nice.
Remember to print the endstop.
Install and setup should be easy, if you place the nuts inside before pulling up the wood frame. If you are use to do this kind of stuff it should be pretty straightforward.
Materials and methods
Some 14-16mm m3 screws might be needed to replace the screws you remove. I'm so really busy and I did this on the fly, so I would need to get some free time to write all down. But soo busyy!!
Documents
Edit in 3dslash
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
Comments
MayolaLove added this to the Mayola collection ago
Ryan Lake added this to the Ultimaker Original+ Upgrade collection ago
fcristy28 added this to the Ultimaker UMO collection ago
ataraxis commented agoHum, why did he remove his design? Isn't it working?
Bill Murphy added this to the UM - Todo collection ago
Neotko / Sugarpop! commented agoIndeed Gudo removed his mod, I think you should ask him. Send him a pm on the http://www.3dprintingforum.us
Ivan Matijevic commented agoHey, could you link the original mod? I have tried searching for "Gudo's Bed Stabilizer" to no avail.
nilrog added this to the Ultimaker extras collection ago
Erik de Bruijn added this to the UM Original upgrade collection ago
Neotko / Sugarpop! published this design ago