Air Hockey Robot (an OPEN SOURCE 3D printer hack)
Based on the idea of using standard RepRap 3D printer parts : NEMA17 stepper motors, drivers, Arduino Mega, RAMPS, belts , bearings, rods, printed pieces … A fully functional robot to play with!Maker/DIY
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Take a look to http://jjrobots.com/air-hockey-robot-a-3d-printer-hack/
You will find there the Bill of materials and instructions about how to create your own AIR HOCKEY ROBOTIC TABLE (I will give you an advise... it is not easy to beat!) :-D
ENJOY IT! (and if you need a helping hand go to the JJROBOTS forum http://jjrobots.com/forum/)
Materials and methods
Issues are used to track todos, bugs or requests. To get started, you could create an issue.