Grid for the classic Artilux magnetic ball lamp.
The original grid is commonly missing on these lamps since it was destroyed by the heat from the bulb.
I had none of the grids left, so I designed a replacement based on a picture I found on Internet.
READ THIS BEFORE PRINTING:
- For this to work, you need to use a LED-bulb, incandescent bulbs will melt the printed grid, just as it did with the original grid.
- Try to get a LED-bulb not more than 85 mm long.
- Use supports when printing.
- There are at least two versions of this lamp. This grid will only fit the one that uses three holes in the reflector to fix the grid.
Creative Commons Attribution Share Alike