Bearing Bike 02A

Print in place toy bike using 625z bearing idler pulleys

Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

::UPDATE::
Tweaked the axles (wheel pins) - hopefully they will not break as easily and the wheels still go on without issue

A print in place Akira inspired bike (Shotaro Kaneda's bike) with articulable steering, and utilizes two 625z bearing plastic wheel pulleys

My particular pulleys were 10.4mm x 24mm

No support needed

It's a good calibration test object as it has some bridging, tight spacing, etc, and it takes less than 1 1/2 hours to print at 40mm/s.

print flat with no support. two 625z idler pulleys needed

Issues are used to track todos, bugs or requests. To get started, you could create an issue.

Sampey added this to the PUPAZZI E GIOCHI collection almost 3 years ago

Luu Lac published this design almost 3 years ago