Thanks for downloading!
We'd love to hear from you if the print was successful.
BlueStack Micro Plus / DVMega Enclosure
Case for BlueStack Micro Plus and Dual Band DVMega
Maker/DIY
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
This is a case designed to fit the BlueStack Micro Plus and DVMega Dual Band Raspberry Pi board (not sure if this will fit the mono band DVMega).
Print with PLA, .3mm Layer Height - I have been using 25% infill with .8mm shell.
Orient the main body so that the end opposite of the open end is on the build plate (orienting the whole thing on its end to minimize need for support). Support is recommended for filling in the corner that the antenna posts through.
Materials and methods
Print with PLA, .3mm Layer Height - I have been using 25% infill with .8mm shell.
Orient the main body so that the end opposite of the open end is on the build plate. Support is recommended for filling in the corner that the antenna posts through.
Documents
Edit in 3dslash
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
