Thanks for downloading!
We'd love to hear from you if the print was successful.
Bowden Locking Clamp Clip
This replaces the normal small blue clamp clip underneath and around the tube coupling collet for the Ultimaker2. It forces the collet to lock the tube in place much better.3D printer parts and enhancements
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Make sure the bed is well glued with the glue stick.
Printed in PLA.
Update (3july2014)The first upload was 2.5mm thick.Now also uploaded other heights like 1.25, 1.5, 1.75, 2.00, 2.25 and 2.50mm
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
And I found out that is actually blocks the printhead to go to the max y position. I think that is the reason OTO41 left the lower part free: https://www.youmagine.com/designs/bowden-clip
If it's too small, why not make the hole a little bigger in the design?
- Printed on:
- Ultimaker - The Ultimaker 2
- Fits perfectly!
- The fit was just a bit too tight with just the 6mm drill, I jused 6.5mm and then it fit well.