Quick and simple Test Part3D printer parts and enhancements
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Test Part (successor of Test_C)
outer dimensions 30x30mm
round hole 10mm
square hole 10x10mm
2x 45° bevel
Materials and methods
Do not measure on the bottom of the part as Prints normally tend to have "elephant foot"
measure some layers above.
Print with 3 Perimeters, 3 Top/Bottom Layers, about 30% infill and not too fast (max 30mm/s print/travel) to get accurate results
Issues are used to track todos, bugs or requests. To get started, you could create an issue.