<div>This is an ulti-bot that you can print. With the file attached you can make an autoprint (if you run it in windows). It is designed so you can shove it over a Christmas light in your tree. It has a 10mm hole, so scale it accordingly until it fits over the lights you have in your tree! <br><br>Note: The autoprint works for the Ultimaker Original only at this point.<br><br>Instructions:<br>-Unzip the folder.<br>-Open the script.<br>-Enter the amount of robots you want to print.<br>-Autoprint is being generated.<br>-Copy and paste the file on your SD card.<br>-Use some 'used/old' tape, or wear it down with a bit of sandpaper, you don't want the robot to stick too well to your tape, or your printhead won't be able to push it off.</div><div>-Start autoprint. <br><br></div><div>Let the light shine in your house :)</div>
Creative Commons Attribution Share Alike
