Thanks for downloading!
We'd love to hear from you if the print was successful.
Cooling Fan/Shroud with 4cm Blower and Sensor for Wanhao D6/Ultimate
Cooling Fan/Shroud with 4cm Blower and Sensor for Wanhao D6/Ultimate
Other
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
This shroud is printed in two parts that slide together. Included is a M12x1mm nut for the proximity sensor. You also need to print two of the 5x6mm posts and remove a small bridge between the holding posts for the fan on the shroud.
I used a GDStime Technology 24V 0.1A 40mm blower. At 100% the output is about what a 50mm blower (http://www.thingiverse.com/thing:2235389) does at 25-30%.
2x 10mm M2 and 2x 12mm M2 and nuts to fix the Fan in place
The probe is the Omron Manufacturer Part #: E2B-M12KN08-WP-B1 2M which is PNP and it works with a 7805 to reduce voltage down to 5V and the PNP Configuration.h of the Marlin duplicator 6 firmware. This probe has a working distance of 8mm in a M12 form factor. Screw the probe in so that it is flush with the bottom of the shroud. This setup works with a 1mm PEI sheet glued on the build plate.
Same position as in 1bigpig's probe mount http://www.thingiverse.com/thing:2081168 where you also find the description on how to set up the probe.
Materials and methods
PETG 0.150mm
Documents
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.