Thanks for downloading!
We'd love to hear from you if the print was successful.
Crawler Harness Holder
This is the main part for a crawler harness holder that you can complete simply by gluing some foam or cork to the smaller diameter parts of this print.
Other
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Attribution
My Tackle Box
Description
Make sure one end is down on the build plate when slicing, no support should be necessary
I printed this at 80 mm/s with 25% fill and 0.6mm wall thickness, it shouldn't need to be any stronger or more precise
Keep the layer height small to avoid the need for supports. I would recommend 0.2mm layer height
Print should take about 2.5 hours depending on your speeds, infill, wall thickness etc.
Once print is completed, cut 3 strips of foam or cork to fit the three smaller diameter sections
Glue and use a rubber band or masking tape to hold foam or cork in place until adhesive is dry
Assembly should take about 10 mins plus additional time for the glue to dry
Documents
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.