Let your opponent know who you are by proudly flying a Monogrammed version of the standard Seej Battle Flag.  

Seej game can be found here: https://www.youmagine.com/designs/seej-starter-set

The flag is small so try to use under 6-8 letters. The letters will get too thin to print if you add too many. (see photos)

Download the openSCAD file, and add you own text.

Have Fun, and share picts of any flags you make.

Each Seej Battle Flag will need one each:
-your customized flag stl
-flag post
-flag off set base

SPECIAL NOTE! about the setting for descending lowercase characters..(and some "normal" BlackRose characters that dip below the standard bottom of the line). Use this setting to move the text up if any letter bottoms are getting cut off..like descending lowercase letters(like y,g,p,etc), this setting will move the text up so they are not cut off. BUT if you do not have descending lower case letters then this setting will cut the tops off! Yikes!

Since the letters make the flag heavier you should use the offset base included so it will not topple over due to the heavier flag.