Thanks for downloading!
We'd love to hear from you if the print was successful.
Cute flower pot
Cute flower potFor your home
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Supports or rafts: This part does not need supports or rafts. The last layers of the object have been designed as a bridge and not as a dome. Also, the bridge is inside and therefore there is no point to waste material.
Perimeters: Three lines perimeter.
Layer Height: Low layer height, i.e. 0.1 mm. It affects mostly the last layers, which is the bottom of the model. A higher layer can be used, but it will not make a nice bottom surface (or top during 3D printing). However, because the object is placed upside down, you will not be able to notice this detail. Otherwise, use a high layer for the most of the part and at the end of the object use 0.1 mm.
Printing speed: High printing speed, with low to medium gap speed. However, the high speed can ruin the object's surface due to the vibrations.
Travel speed: High.
The white pot of the picture has been printed with simple PLA and the other two with a carbon filament:
Issues are used to track todos, bugs or requests. To get started, you could create an issue.