Thanks for downloading!
We'd love to hear from you if the print was successful.
DADDY personalised USB case for Father's Day
USB case dedicated to DADs. To create your own model visit http://customflashdrive.co.uk/3d-print-your-own/Gadget
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
USB case dedicated to DADs. It can be a nice hand-made present for the coming Fathers' day as well. For suitable memory stick visit amazon at http://www.amazon.com/V7-Mini-Flash-Drive-VU24GCR-YLW-2N/dp/B00AZG90E6/.
These models do not need any support while printing.
0.8 mm wall thickness and at least 15% infill is recommended for stability.
For more models visit http://customflashdrive.co.uk/3d-print-your-own/
Materials and methods
Printing Parameters for PLA material as written at http://customflashdrive.co.uk/3d-print-your-own
Wall Thickness: 0.8 mm – The Extrusion Width of our printer’s nozzle is 0.4 mm. Therefore 1 shell is not enough to provide sufficiant strenght, however 2 shells and a total wall thickness of 0.8 mm gives a good print result. This will be a strong and durable USB case in fact.
Infill: 15% – Minimum 15% infill is recommended for stability. Otherwise the outcome might easily brake. Please use this setting for satisfactory result. Obviously you can higher the percentage of infill, but do not lower them for the sake of strength and durability. This is a honeycomb-shaped infill. In case you use this setting of 15% infill one print will take about 30 mins, no more.
Printing Speed: 150 mm/sec – Printing Speed has an influence on quality. This speed might seem to be too fast, but it was tested before, like every other parameter.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.