×Read this message from Erik, founder of YouMagine

Issue Printing the upper half of the shroud #5

Diving_Dan opened this issue on August 20, 2020 17:50

How is best to print the upper half of the shroud as printing using the guidance given has caused problems when it gets to the vent for the air to come through. Did you use support everywhere?

    Comments

    573d7547537d7474192121a2f78e0d72?default=blank&size=40Daniel Goldman closed this issue ago
    573d7547537d7474192121a2f78e0d72?default=blank&size=40Daniel Goldman commented ago

    It's ok I've added some custom supports

    573d7547537d7474192121a2f78e0d72?default=blank&size=40Daniel Goldman created this issue ago

    Back to Desktop Bladeless Fan V2