<p>I have designed this large tree to mount our digibirds. The tree is printed in several parts and can put together resulting in a 40x40x40 cm object. The only drawback: you need 7 digibirds ;)</p><p>The design was made using Fusion 360 and printed on an Ultimaker O+.</p><p>See <a rel="nofollow" target="_blank" href="http://youtu.be/5Sq-bM0AXUo">http://youtu.be/5Sq-bM0AXUo</a></p><p><br></p><p>Printing suggestions:</p><p>- I used colorfabb PLA chocolate brown for the branches and (naturally) leaf green for the leafs.</p><p>- The root and supports were printed at 100 mm/s (210 degrees) without support or brim. The large branches I printed using a brim to keep them standing up during printing. The whole tree can be joined mechanically.</p><p>- For the leafs I used a brim & supports in order to be able to print them (at 50 mm/s, 190 degrees). They come at several sizes and can be mechanically joined with the knot. However, for the smallest leafs I finally ended up glueing them together with the knot as the part became to flimsy.</p>
Creative Commons Attribution Noncommercial Share Alike
