This is an updated version of my previous design
( V1.2 https://www.youmagine.com/designs/direct-drive-extruder-mount-v1-2 )
Updates:
*it is now possible to install E3DV6 heating unit, which uses a thermistor in a metal cartridge
*in the previous version, it was not possible to install the motor with the drive gear installed according to the recommendation of the BMG extruder manufacturer due to the impossibility of positioning the motor at the required entry angle. The gear had to be turned backwards. This issue has now been fixed.
*increased hole for fan cable management
*model cooling fan is now installed slightly higher for more free air flow and is fixed with two screws instead of one
*some minor changes in dimensions

This design is based on three concepts:
it should be a one-piece part
it must have a good view of the nozzle
it should be compact and use the minimum volume to the maximum

It is designed for Bondtech BMG (or clone) extruder, E3DV6, BLTouch (or analogs), 40x10 or 40x20 fan and 5051 model cooling fan.

Adapted for Tevo Nereus, but in the files list you can find STEP file and remix it for your printer.

Installation of fasteners for ABL sensor is implied using a soldering iron.