This is a re-mix of NeoTko's Symmetric Dual Fans (1) to fit my E3D-v6 hot end mount (2).
The plate needs to be rigid, you should cut it in fiber based material (carbon, G10, ...).
The fan shroud is the "For Amedee Mod Umofancap40x40v3" from NeoTko in (1), with the center hole adjusted for the E3D hot end.
You need to extrude 2 mm of the top part of the fan cap, or use the "For Amedee Mod Umofancap40x40v3 Scalabletops" from (1).
Creative Commons Attribution Noncommercial Share Alike