Thanks for downloading!
We'd love to hear from you if the print was successful.
Easy Print Airfoil for MKII Nano Wind Turbine
Easy Print Airfoil for MKII Nano Wind TurbineMaker/DIY
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Easy Print Airfoil for MKII Nano Wind Turbine:
Blade is split for easy printing in smaller print volumes. Stainless steel pins for alignment. M5 hex nut volume was increased by %0.2 (yes, less than 1%) as the original did not have clearance for any M5 nuts in my inventory.
Materials and methods
This was printed on a Monoprice Maker Ultimate in eSun ABS+. 55% infill .150 layer height. 248/105 temps