×Read this message from Erik, founder of YouMagine

Easy Ultimaker bed calibration

Place above the bottom wooden piece of the print head and block with nut. Move the bed until tip touch platform then move print head to each corner and adjust the bed until pen can draw a solid line over perimeter. Adjust z end-stop, remove pen holder and you' re ready to print.

Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

Issues are used to track todos, bugs or requests. To get started, you could create an issue.

Tycho commented about 6 years ago

Would you have a picture of the actual configuration?

kesjeff added this to the Ultimaker collection about 6 years ago

alan89 published this design over 8 years ago