Thanks for downloading!
We'd love to hear from you if the print was successful.
A small egg piercer with magnetsFor your home
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
A small egg piercer. The magnets can be press fit into the big holes. Put the needle with the point inwards in the small hole at the end. Cut the needle about 1 or 2 mm from the PLA piece, then take it out again, fill the hole with superglue, turn the needle around 180 degrees and stick it in there. When the glue has set, you have a tiny egg piercer that can be stuck on your fridge.
Materials and methods
Two magnets, diameter 4mm, thickness 2mm.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.