Elegant iPhone 6 Plus dock

A simple, yet elegant dock for the iPhone 6 Plus. It has space for the original charge cable and channels for the speaker and microphone. The design is made with Colorfabb Woodfill in mind as seen in the pictures but obviously you can use any material you like.


Creative Commons Attribution Share Alike

Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

Learn more or download attribution tags


Because I couldn’t really find a design I liked on Thingiverse or Youmagine, i decided to design my own. I designed it with Colorfabb Woodfill – a wood like material – in mind, because since I finally got it to print, it’s by far my favorite material to print with. Surfaces get really smooth, and if you print at 0.15mm layers, sloped surfaces also look very nice. The roughness of the material is very forgiving, and at the same time it makes the design look really finished and professionally produced. Of course you can print it in any material, but I think it looks best in Colorfabb Woodfill.

The iPhone 6 Plus dock has space for the original charging cable and has channels for the microphone and speaker at the bottom of the phone.

Supports are not needed to print this design. The channels are optimized for this, and your printer shouldn’t have a problem with bridging the small gap behind the connector.

If you want me to print it for you, you can order it through my hub on 3DHubs: download the design here and upload it on 3DHubs.

Materials and methods

- Design in the pictures is printed in Colorfabb Woodfill, but any material should work.



Issues are used to track todos, bugs or requests. To get started, you could create an issue.


80203b609401c8c55dd04375e790f944?default=blank&size=40BjornTM commented ago

Ehm.. There should be.. It's for the speaker.

11f0876046561427caaf74ddb8b0a91a?default=blank&size=40Oscar Modroño Rodríguez commented ago

It leaves me a big hole in the left side of the dock!!

Mini img 3408Fritz Toch printed this ago
Carousel thumb img 3439
Printed on:
Mbot-3D - MBot Cube II Dual Head
Good results with BotFeeder PLA
The fit is loose with one Lightning cable, and impossibly tight with another. Not a fault of the design, but a reminder that some tweaking may be necessary.
80203b609401c8c55dd04375e790f944?default=blank&size=40BjornTM published this design ago