This design is based on the specifications as the gateway is not available yet!
This is a remix of my RAK831 enclosure, this time for the PiSupply Gateway based on the RAK833 PCIE module.
Front and back panels are available in 2 flavours: with or without the PiSupply IOT logo embossed.
If you print with 0.2mm layers, the logo will only appear in the last layer.
The design is optimized for a 0.35 nozzle and it prints very easily without any support.
Aside the Raspberry Pi and the PiSupply LoraWan gateway you will need:
4 M2.5x12 to secure the Raspberry Pi
4 M3x8 + 3 M3 nuts for the feet
4 M3x8 round head to close the enclosure
Creative Commons Attribution Noncommercial Share Alike