×Read this message from Erik, founder of YouMagine


Mini Motorized Foam Dart Launcher


Creative Commons Attribution Noncommercial Share Alike

Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

Learn more or download attribution tags


3D printed Dart Launcher that used motors and flywheels to launch darts up to 70 feet, All 3d parts can be printed without any support material. Takes about 15 hours or so to print all the parts. All parts lock together via little tabs and then zip ties are used to clench the pieces up nice and tight.

Materials and methods

PLA Filament printed at .3
2 motors (edited 11-03-2016 had the wrong motor listed.. sorry about that.. the one I listed will still work it just won't last long.. use the one below)
8 zip ties
1 rubber band
4AA Batteries
1 plastic AA battery holder



Issues are used to track todos, bugs or requests. To get started, you could create an issue.


Mini ch30x30mfgeflammtMichael Hafner added this to the Cooooool collection ago
Mini 19875 342488998744 2836777 n v2Evolution3D published this design ago