Print at: 95% infill with 3 or 4 top layers. You should observe small gaps while infill is printing and no gaps when top layers print. Added mini version for getting the rough dial-in without printing such a large model.

• Calibration
• extrusion rate

Creative Commons Attribution Share Alike

Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

Learn more or download attribution tags

Description

Materials and methods

- 95% infill
- 3 or 4 top layers
- Decrease extrusion rate if you cannot see gaps during infill
- Increase extrusion rate if you see gaps in top layer

Documents

Comments

Leave a comment

Log in to leave a commentDon’t have an account yet? Sign up here!

rcozta added this to the calibrations collection over 2 years ago

Rob .__ added this to the Calibration collection about 4 years ago

Ruben van Tienen added this to the Printer collection almost 5 years ago

Bruno Porto added this to the Tests collection over 5 years ago

Menno van Dellen added this to the Todo collection over 5 years ago

UncleZombie added this to the Calibration collection almost 6 years ago

saviowong added this to the UM3 collection about 6 years ago

Aron Bailey added this to the UMO+ collection almost 7 years ago

Anurag Choudhury added this to the Testing collection about 7 years ago

Wapameepto added this to the 3D Printer collection over 7 years ago

doodaddoes published this design almost 8 years ago