Thanks for downloading!
We'd love to hear from you if the print was successful.
Face shield prototype
easy to do, only plastic sheet needed
COVID19
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
Deutsch unten
This es an easy to build prototype of a face shield. You need:
- 3D (fdm) Printer
- A4 plastic sheet (e.g. 0.2mm pet foil)
Just print the file, then put holes in the plastic (as in template) and push it through the visor frame. Adjust the frame by heating up (warm water) the PLA frame in the front.
The distance from the top of the hole closer to the side adjusts the distance from the nose (the further down the closer to the nose)
Dies ist eine einfach Version eines Gesichtsschilds. Man braucht:
- 3D Drucker (fdm)
- Din A4 Plastikfolie (Laminier/Coverfolie 0,2mm)
Einfach ausdrucken, dann die Löcher nach Anleitung in die Plastikfolie einbringen und durch den gedruckten Rahmen schieben.
Anpassen des Rahmens an Kopfgröße möglich durch Erwärmen des Rahmens in der Front mit warmem Wasser.
Die Distanz des Loches A (näher am Rand der Folie) von der Oberkante der Folie regelt den Abstand des Visiers von der Nase. (je größer die Distanz desto näher an der Nase)
Den Abstand der Löcher kann man auch weiter nach oben setzen. Die Löcher am besten mit einem Skalpell Cutter als Kreuz einbringen oder mit einem normalen Locher (schwer wg. Abstand der Folie).
Druck aus PLA / print in PLA
0.3 mm layer height
only walls
final->preferred model
stacks-> print with brim (10-15lines)
dicker-> reduced risk of warping/better build adhesion with my printer due to wider bottom
Materials and methods
PLA, plastic sheet A4 (0.2mm)
Documents
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.