Guide3D printer parts and enhancements
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
The Filament Support is designed to fit into a 15mm x 15mm Aluminium profile beam without requiring any screws.
Identify the location were you wish to mount the support and place the small end into the cavity and rotate by 90 degrees to lock the support in place.
Feed the filament through the centre.
Printer: Labists ET4
Materials and methods
No tools are required to fit or remove the guide.
Simply twist to fit and twist to remove.
There is no specific requirements for Post Processing.
However, as the filament guide is a continuous ring the option exists to cut an opening subject to the direction of the filament tension.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.