Thanks for downloading!
We'd love to hear from you if the print was successful.
Filament Guide Ultimaker 2
My original Filament Guide broke right away - so i made a new one.3D printer parts and enhancements
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
The Stilt goes through the hole. Glue the Stilt into the Plate. Then put the Roller on the Stilt - it should move freely. Put the Top on the end of the Stilt - done. Print each part speratly so you don't get spilkes from the retraction. I printed mine with PLA, 210°C, 75 Bed, 50mm/s, 0.1 Layer Height, 0.3 initial Layer height and 100% infill.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.