Thanks for downloading!
We'd love to hear from you if the print was successful.
Filament Guide UM2
A filament guide for the UM2 to straighten the filament in the feeder3D printer parts and enhancements
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Filament guide that fits under the Ultimaker 2.
Print the four parts and fit them together. The nut must not be screwed to tightly to let the pulley move a bit.
You can print the part with the Ultimaker robot, or the other one if you want to save filament.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
I had to disassemble the filament pusher to get out a little little bit of damaged-off filament. i was now not watching for that the four screws were additionally maintaining the stepper motor in region, and became pretty alarmed once I heard the thud that observed the elimination of the remaining screw.
Essay Writing Service
Now what? there may be no way to assist the stepper motor and pull it towards the back plate so the screws can move in. I can't even keep it in location to install one screw, even with out the filament driving force.
- Printed on:
- ultimaker 2
- Very good, same observations as in another comment so I changed the clipsable part a bit.
- Printed on:
- Ultimaker - The Ultimaker 2
- great design and help - but the actual filament guide roll is too far away from the housing in our opinion - since the feeder sits close, the roll should too. Anyway thank you for your efforts and input!! ;)
- Filament Guide for Ultimaker2 - moving part could be closer to housing as feeder is too...