Thanks for downloading!
We'd love to hear from you if the print was successful.
Filament-Roll-System for one or more rolls together
Filament-roll-system for more than one roll, very cheap
3D printer parts and enhancements
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
This filament-roll-system is very cheap. I use it on my printer-table, which is aN IKEA LACK-table. You need the printed part two times, one on the left, one on the right side. Just fix it to the LACK-table with screws. The "spool" is a cable-tube of 16mm outer diameter, in germany two meters are sold for about 2 or three euros in DIY-shops.
The tubes have a bigger diameter on one side, and this part is on the left side in my case, the right side of the tube has a small hole drilled into and a metal-splint fixes the tube here so it can't slide out of the right holder.
Its no problem to put three or four filament-rolls on it, and its possible to use other spools of same diameter.
Materials and methods
four wood screws, one cable-tube, a little metal-wire, two printed parts
Edit in 3dslashIssues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
Comments
Minihawk published this design ago