Four Tower Castle

This is huge. It should take 15 hours 43 minutes to print as-is. If you drop the floor by 2.6mm you can cut off the floor and shave 1.45hr. Printed at 1:200 scale will take 3.5hrs. This was made using http://www.Imaginary-Spaces.com.

Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

PLA

Issues are used to track todos, bugs or requests. To get started, you could create an issue.

liu bing added this to the construction collection almost 2 years ago

nanosmith commented almost 4 years ago

Not worth printing, model is not manifold with a bunch of holes in the bottom.

g33zer added this to the Toys collection over 4 years ago

Casey added this to the Fun Prints collection over 4 years ago

imgspc published this design almost 6 years ago