The handle on the front of our Kenmore upright freezer snapped off one day. The replacement for the panel that broke is no longer available. About 3 hours in OpenSCAD and a couple of prints were required to get all the parts perfectly aligned.  Works great now!

The design is very large, over 300mm, so it is split into two halves to be printed separately - about 160mm of Z travel is required (Prusa i3 handled it just fine). Gorilla glue to join the two halves, some carpet tape to re-affix the control sticker over the panel. Perhaps glue will be required eventually, as the tape doesn't stick well to the rough output of my printer.