G-slot carriage for delta printer
G-slot is an aluminum extrusion with v-shaped rails. This is a delta carriage to use it.Maker/DIY
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Steel balls are glued with epoxy to the part holes.
Belts are fixed by placing a loop inside the slot and later inserting a piece of filament inside the belt in the loop to keep it from sliding out.
Materials and methods
Two 10mm steel balls.
Four 15mm M3 bolts
Four v-shaped bearings.