Box for a naked GoPro Hero 3 camera. The camera is put in the bottom part with lens down. This way there was room for 4 Micro SD storage slots. On top of the box the text "GoPro Hero3" is engraved.<br><br>It uses my jewelbox.scad (<a rel="" target="" href="https://www.youmagine.com/designs/parametric-jewelbox">https://www.youmagine.com/designs/parametric-jewelbox</a>) and write.scad from <b>HarlanDMii</b> (<a rel="" target="" href="http://thingiverse.com/thing:16193">http://thingiverse.com/thing:16193</a> for complete set of fonts to go with write.scad).<br><br><b>Update:</b> made the scad file more adaptable by adding global variables at the top of the file. The following variables are added (all values are in mm).<br><b>gpx:</b> X dimension of GoPro Hero 3 camera.<br><b>gpy:</b> Y dimension of GoPro Hero 3 camera.<br><b>gpz:</b> Z dimension of GoPro Hero 3 camera.<br><b>gpl:</b> height of lens above main camera body.<br><b>gpo:</b> overlap between to and bottom parts.<br><b>gpw:</b> width of the walls of the box. Keep in mind that the wall thickness at the overlap is (gpw - gpg) / 2. This means with a gpw of 2mm and a gpw of 0.4mm the walls at the overlap are (2 - 0.4) / 2 = 0.8mm (twice my nozzle size) which worked perfectly for me.<br><b>gpg:</b> gap between top and bottom parts (wiggle space). Tune this to get good fit between top and bottom parts. For me the 0.4 (size of nozzle) worked perfectly.<br><b>gpt:</b> depth of the engraved "GoPro Hero3" text on top part. Set to 0 if you don't want any text engraved.
Creative Commons Attribution Noncommercial Share Alike