×Read this message from Erik, founder of YouMagine

Grease caps for 8 and 10mm linear bearings

Caps for greasing linear bearings

3D printer parts and enhancements

    Creative Commons Attribution Noncommercial Share Alike

    Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

    Learn more or download attribution tags


    Just stuff the bearing thoroughly with lithium grease, then put the cap on one end and push in the corresponding rod from the other end to force the grease into the cavities.
    Remove unneeded grease on the outside, then make sure not to get any dirt into the bearings before mounting.
    See the attached pdf file for more detail.



    Issues are used to track todos, bugs or requests. To get started, you could create an issue.


    1a1f0c4043f939c6760bbe43f4adcb53?default=blank&size=40PHabermehl published this design ago