Thanks for downloading!
We'd love to hear from you if the print was successful. If you like the design, please consider donating to the designer.
Donate to ClevenHand Water Pump
Old style hand pump, designed to fit onto a large water bottle. Will work anywhere. Read the Bill of Materials
Maker/DIY
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
Old style hand pump, designed to fit onto a large water bottle. Will work anywhere.Tested it in the sink see the video below.
Materials and methods
2 marbles or balls, find something to plug the hole!
Both need to be over 8mm in Diameter.
One of the balls can be up to 1in. Though smaller the better.
2 or 1 #17 Oring.
(http://www.homedepot.com/p/DANCO-17-O-Rings-10-Pack-96734/100261428)
It should work without the oring just not as well :)
Designed to fit onto 1/2IN ID tubing. The pump primes easily and the length of hose depends on how well of a seal you are able to make.
You should be able to figure out how to put it together. Part 13 is the oring, if you have rubber type filament perhaps you can just print one.
Documents
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.