Headphone Stand Diamond
a diamond shaped headphone standGadget
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
It was time for a new one, so I sketched, extruded and chamfered one.
Originally it is 200mm in height, but I had to split the design for scaling the parts up to 125% to support my headphones.
Materials and methods
There is a one piece stand (0300) which fits in an UM2 (200mm in height), but it is rather small and it needs a lot of supports.
The two pieces version (0301+0302) is the same dimension but this can be scaled up to fit for bigger headphones (the one on the pictures is printed at 125%) and if printed lying on its back side, only few supports are needed.
- printed from PLA
- supports needed (more or less)
Issues are used to track todos, bugs or requests. To get started, you could create an issue.