Hold Down Clamp
Hold Down Clamps in two sizesMaker/DIY
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
I pulled an old clamp out of my workbench and decided to model it in 3D and print it out, turned out pretty good.
Also the hardware I used is 1/4-20, there are a few knobs around you can print or can purchase at hardware stores or on amazon.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.