We are preparing your download, please wait.
Honda Key Housing (unofficial item)
Honda keys have a problem of breaking. This is a redesign of a housing which supports the key at its point of stress. Clips together ready to go.
Gadget
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
Note: This is a design created by a Honda customer/fan. Otherwise, there is no connection between the designer and Honda. This is not an official Honda part. It's not endorsed by Honda and not specifically intended for Honda products.
Included a new design. Key 1 & 2. This was improved for printing with nylon. It should still function with other plastics but it has not been tested other than with nylon. Tip: use a soldering Iron to melt the edges together slightly to hold in place better than glue. If you use the thickers one scale the z up 1%
Honda keys have a problem of breaking. This is a redesign of a housing which supports the key at its point of stress. Clips together ready to go.
Documents
Edit in 3dslash
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
Comments
Santiago Centineo added this to the to print collection ago
Andreas Schwabe added this to the OBJECTS collection ago
cwalker74 added this to the Things to Make collection ago
DaHc added this to the Automotive collection ago
RUSINGENERIS added this to the 1 collection ago
Curt added this to the Automotive collection ago
Sam Director added this to the Project collection ago
Joescottii added this to the Around the house collection ago
Cleven commented agoThere is a newer design on here that gives more room as it is printed on a different axis. (Key 1 &key2 ) I printed this design with nylon which is a bit more flexible. Thickers was the one in pla.
If you have in general a too tight of a fit, scale only the z axis up by 1 % or so and your issue are solved. (Z is the direction of the thickness of the key)
If you use key1 and key 2 it's best to use a lighter or soldering iron to melt the back to keep it on. Especially if it is nylon.
The Bier Gnome commented agoExcellent design, but I tried using this for a replacement housing for a friend, and the thickness of the key caused the housing to either crack or break. I use an Ultimaker 2 extended printer and I am fairly new to 3D printing. If the inner dimensions could be tweaked just a little, this design would be the ultimate bomb for Honda owners!!!!!
Cleven published this design ago