This is a modification to<br>
<a rel="nofollow" target="_blank" href="http://www.dealextreme.com/p/dual-e27-sockets-lamp-bulb-holder-flash-umbrella-bracket-103135?item=6?r=78675737">dealextreme.com/p/dual-e27-sockets-lamp-bulb-holder-flash-umbrella-bracket-103135?item=6?r=78675737</a> <br>
Alone it can be used for lighting video with 2 or in conjunction with<br>
<a rel="nofollow" target="_blank" href="http://www.dealextreme.com/p/e27-to-dual-e27-light-lamp-bulb-adapter-converter-94131?item=2&r=78675737">dealextreme.com/p/e27-to-dual-e27-light-lamp-bulb-adapter-converter-94131?item=2&r=78675737</a><br>
with 4 light bulps as a very strong video light.<br>
With a large umbrella it's a soft and and without a hard video light.<br>
<br>
When you want photo and video, this modification allows to place a flash on the same umbrella.<br>
The hot show is tapared to allow for easy insertion of the flash.<br>
<br>
<br>
I provided a technical drawing with the dimentions and spacing used, in
case someone wants to design a different moficiation for this umbrella
holder.<br>
<br>
<br>
<b>blog posting:</b><br>
<a rel="nofollow" target="_blank" href="http://marcuswolschon.blogspot.de/2012/08/umbrella-flash-holder.html">marcuswolschon.blogspot.de/2012/08/umbrella-flash-holder.html</a><br><br><br><b>Instructions:</b><br>Unscrew the top plate.<br>
Keep the 2 screws.<br>
Slide on this part and insert the screws into the 2 center recesses.<br>
You can use 4 additional screws for the edges. The original part has holes for 4 additional screws but does not use them.<br>
<br>
It can be a snug fit if your layer height is too large. In that case try to insert a flash while the plastic is still warm.<br>
<br>
The print you see was aborted after that damn Thing-o-Matic failed after
25 of 60 minutes. (The usual extruder-jamming when the PLA gets too hot
due to an obvious design fault of the hot end.)
Creative Commons Attribution Noncommercial Share Alike