Thanks for downloading!
We'd love to hear from you if the print was successful.
Inholland model rocket
Inholland model rocketEducation
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
A 3D printed model rocket for a model flight competition. It's part of the Inholland University lesson plan that is attached with the STL-files
Build volume 23 cm × 22.5 cm × 20.5 cm
Build volume 21.5 cm x 21.5 cm x 20 cm
Its just a little too big... too bad too I really want to print this one!
partsoven: "Lower part with fins is too big to fit in my UM3 extended... :("
That is weird because it does fit in our UM2 extended without scaling in Cura
Lower part with fins is too big to fit in my UM3 extended... :(
- Printed on:
- Ultimaker 2 Extended
- https://vimeo.com/195787703 skip to 0:44. Grey rocket is the printed one
Skip to 0:44. The gray rocket is the fully 3D printed rocket with the files above :)